- 您现在的位置：买卖IC网 > Sheet目录629 > PAXCDL10 (Red Lion Controls)ANALOG OUTPUT CARD
1.0 I NSTALLING
THE
M ETER
Installation
The PAX meets NEMA 4X/IP65 requirements when properly installed. The
unit is intended to be mounted into an enclosed panel. Prepare the panel cutout
to the dimensions shown. Remove the panel latch from the unit. Slide the panel
gasket over the rear of the unit to the back of the bezel. The unit should be
installed fully assembled. Insert the unit into the panel cutout.
PANEL
BEZEL
While holding the unit in place, push the panel latch over the rear of the unit
so that the tabs of the panel latch engage in the slots on the case. The panel
latch should be engaged in the farthest forward slot possible. To achieve a
proper seal, tighten the latch screws evenly until the unit is snug in the panel
(Torque to approximately 7 in-lbs [79N-cm]). Do not over-tighten the screws.
Installation Environment
The unit should be installed in a location that does not exceed the operating
temperature and provides good air circulation. Placing the unit near devices
that generate excessive heat should be avoided.
The bezel should only be cleaned with a soft cloth and neutral soap product.
Do NOT use solvents. Continuous exposure to direct sunlight may accelerate
LATCHING
SLOTS
PANEL
LATCH
the aging process of the bezel.
Do not use tools of any kind (screwdrivers, pens, pencils, etc.) to operate the
keypad of the unit.
PANEL CUT-OUT
LATCHING
TABS
PANEL
GASKET
PANEL
MOUNTING
SCREWS
2.0 S ETTING
THE
J UMPER
AND
DIP S WITCHES
To access the jumper and switches, remove the meter base from the meter
case by firmly squeezing and pulling back on the side rear finger tabs. This
should lower the latch below the case slot (which is located just in front of the
finger tabs). It is recommended to release the latch on one side, then start the
other side latch.
2.1 SETTING THE JUMPER
The meter has one jumper for user input logic. When using the user inputs
this jumper must be set before applying power. The Main Circuit Board figure
shows the location of the jumper and DIP switch.
Warning : Exposed line voltage exists on the circuit boards. Remove
all power to the meter and load circuits before accessing inside of
the meter.
2.2 SETTING THE INPUT DIP SWITCHES
The meter has six DIP switches for Input A and Input B terminal set-up that
must be set before applying power. NOTE: The PAXR only uses switches 1-3.
The user input jumper determines signal logic for the user inputs, when they
are used with user functions or for input signal direction. All user inputs are set
by this jumper.
Input B LO Freq.
Input B SRC.
Input B MAG.
Input A LO Freq.
Input A SRC.
6
5
4
3
2
HI Freq.
SNK.
Logic
HI Freq.
SNK.
Main
Input A MAG.
ON
1
Logic
Circuit
Board
Factory Setting
SWITCHES 3 and 6
HI Frequency : Removes damping capacitor and allows max. frequency.
LO Frequency : Adds a damping capacitor for switch contact bounce. Also
limits input frequency to 50 Hz and input pulse widths to 10 msec.
INPUT SET-UP
DIP SWITCHES
SRC
USER
INPUT
JUMPER
SNK
SWITCHES 2 and 5
SRC .: Adds internal 3.9 K ? pull-down resistor, 7.3 mA max. @ 28 VDC,
V MAX = 30 VDC.
SNK .: Adds internal 7.8 K ? pull-up resistor to +12 VDC, I MAX = 1.9 mA.
SWITCHES 1 and 4
LOGIC : Input trigger levels V IL = 1.5 V max.; V IH = 3.75 V min.
MAG : 200 mV peak input (must also have SRC on). Not recommended with
counting applications.
7
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
PAXLC800
COUNTER 8-DIGIT BI-DIR COUNT
PAXLPT00
METER PROCESS TIME 6-DIGIT
PAXLR000
METER RATE INDICATION 6-DIGIT
PB52233SLK
PROJ BOARD COLDFIRE M52
PD412411
DIODE MOD ISO DUAL 2400V 1100A
PF24-30
TRANSFORMER LO PRO 15VAC 1.6A
PFT12-28
TRANSFORMER 16VCT 28VCT 12VA
PFT12-35
TRANSFORMER 16VCT 35VCT 12VA
相关代理商/技术参数
PAXCDS10
功能描述:DUAL POINT RELAY OUTPUT CARD RoHS:是 类别:继电器 >> 配件 系列:PAXCDS 其它有关文件:Declaration of Conformity 标准包装:1 系列:- 附件类型:散热片 技术规格:3.5° C/W 适用于相关产品:Multiple 系列 颜色:-
PAXCDS20
制造商:Red Lion Controls 功能描述:Card, Plug-In; + 0.01% 10 ms; Quad Setpoint Relay Output Card; PAX Series 制造商:Red Lion 功能描述:Bulk 制造商:Red Lion Controls 功能描述:QUAD RELAY CARD 制造商:Red Lion Controls 功能描述:OUTPUT MODULE RELAY 制造商:Red Lion Controls 功能描述:OUTPUT MODULE, RELAY 制造商:Red Lion Controls 功能描述:QUAD SETPOINT RELAY OUTPUT INTERFACE CARD; Accessory Type:Quad Setpoint Relay Output Interface Card; For Use With:Red Lion PAX Digital Input Panel Meters ;RoHS Compliant: Yes
PAXCDS30
制造商:Red Lion Controls 功能描述:Panel Meter, OptionCard for Dual Rate Totalizer, Quad Setpoint Sinking Output 制造商:Red Lion Controls 功能描述:QUAD NPN-OC CARD
PAXCDS40
制造商:Red Lion Controls 功能描述:Card, Plug-In; + 0.01% 10 ms; PAX Series 制造商:Red Lion Controls 功能描述:QUAD PNP-OC CARD 制造商:Red Lion Controls 功能描述:SOURCING OPEN COLLECTOR OUTPUT INTERFACE CARD; Accessory Type:Quad Setpoint Sourcing Open Collector Output Interface Card; For Use With:Red Lion PAX Digital Input Panel Meters ;RoHS Compliant: NA
PAXCK000
制造商:Red Lion Controls 功能描述:Timer; Red, Sunlight Readable; 0.56 in.; 18 VA; 85 to 250 VAC; 2300 V (RMS) 制造商:Red Lion Controls 功能描述:CLOCK/TIMER FIELD UPGRADEABLE 制造商:Red Lion Controls 功能描述:DIGITAL MULTIFUNCTION TIMER RTC 制造商:Red Lion Controls 功能描述:DIGITAL MULTIFUNCTION TIMER, RTC 制造商:Red Lion Controls 功能描述:DIGITAL MULTIFUNCTION TIMER; Supply Voltage Range:85V AC to 250V AC; Time Min:0.001s; Time Max:1h; Power Consumption:18VA; Panel Cutout Height:45mm; Panel Cutout Width:92mm; Character Size:0.56"; Display Font Color:Red ;RoHS Compliant: NA 制造商:Red Lion Controls 功能描述:DIGITAL MULTIFUNCTION TIMER, RTC; Supply Voltage Range:85V AC to 250V AC; Time Min:0.001s; Time Max:1h; Power Consumption:18VA; Panel Cutout Height:45mm; Panel Cutout Width:92mm; SVHC:No SVHC (19-Dec-2012); Count Speed Max:50Hz; ;RoHS Compliant: Yes
PAXCK010
制造商:Red Lion Controls 功能描述:CLOCK/TIMER, FIELD UPGRADEABLE RED DC 制造商:Red Lion Controls 功能描述:DC CLOCK/TIMER FIELD 制造商:Red Lion Controls 功能描述:DIGITAL MULTIFUNCTION TIMER RTC 制造商:Red Lion Controls 功能描述:DIGITAL MULTIFUNCTION TIMER, RTC 制造商:Red Lion Controls 功能描述:DIGITAL MULTIFUNCTION TIMER; Supply Voltage Range:11V DC to 36V DC; Time Min:0.001s; Time Max:1h; Power Consumption:14W; Panel Cutout Height:45mm; Panel Cutout Width:92mm; Character Size:0.56"; Display Font Color:Red ;RoHS Compliant: NA
PAXCK100
制造商:Red Lion Controls 功能描述:CLOCK/TIMER, FIELD UPGRADEABLE GREEN 制造商:Red Lion Controls 功能描述:CLOCK/TIMER FIELD UPGRADEABLE
PAXCK110
制造商:Red Lion Controls 功能描述:CLOCK/TIMER, FIELD UPGRADEABLE GRN DC 制造商:Red Lion Controls 功能描述:DC CLOCK/TIMER FIELD UPGRADEABLE